Phoenix HV-45 ESC

This is the Castle Creations PHOENIX-45 High Voltage Electronic Speed Control.
For use with Brushless motors only.

FEATURES: Extremely Low Resistance (.003 Ohm)
High rate adjustable switching
Up to 45A max continuous current
Dual Opto-Coupled (No BEC)
Up to 36 cells or 12S Lithium Polymer - Maximum
16 cells or 3S Lithium Polymer - Minimum
13AWG wiring for motor and battery leads
Dynamic braking ensures folding props fold promptly
User Programmable Features:
-Low-voltage cutoff with Auto-LiPo detect as default
-Over-current Protection
-Brake Type
-Throttle Range - Fixed/Self-Adjusting/Governor
-Timing Advance
-Cutoff Type
-Soft Start Ramp Up
-Switching Frequency
Runs motor in forward OR reverse
Overtemp Motor Cutoff with Reset
Safe "Power On" arming program ensures motor will not accidentally
turn ON
Low torque "soft start" prevents damage to fragile gearboxes
Auto Shut Down when signal is lost or because radio interference

INCLUDES: One PHOENIX-45 High Voltage speed control w/Universal connector
One set of instructions
One small "Castle Creations" decal

REQUIRES: Bullet-type motor connectors.
Suggested Connectors: 3.5mm (GPMM3112/GPMM3113)
Battery Connectors - depends which connector is used on battery.
Suggested Connectors: Ultra plugs (WSDM3001)

SPECS: Speed control body length: 2.6" (66mm)
Speed control body width: 1" (25.4mm)
Speed control body thickness: .5" (13mm)
Motor wire lead length: 4.8" (122mm)
Battery wire lead length: 6" (152mm)
Servo wire lead length: 11" (280mm)
Continuous current: 45A
Up to 36 cells or 12S Lithium Polymer: Maximum
16 cells or 3S Lithium Polymer: Minimum
Wire size for motor and battery leads: 13AWG

COMMENTS: This speed control does NOT feature BEC. You must use an alternate
power source for your receiver and servos.